Adjusting the Belt Tension (2nd Gen)

You will occasionally need to tighten the belt tension on both the 1st and 2nd generation boards. If your board is making a loud sound on braking, this is a sign you need to tighten the belts.

To adjust the belt tension of the 2nd generation board, use a 3mm allen key to remove the two holding the motor cap on. Using the same 3mm allen, loosen the 4 motor screws exactly 1/2 turn from snug. Wrap your fingers around the motor and use your thumb to press against the wheel, pulling the motor away from it and putting tension on the belt. You should be pushing with a medium force, no need to go crazy.

While maintaining tension, tighten the two vertically aligned screws farthest from the motor first. Once they're tight, let go of the motor and tighten the two remaining screws closest to the wheel. Reinstall the motor cap and you're good to go.

Was this article helpful?
8 out of 10 found this helpful



Article is closed for comments.

Can't find what you're looking for?

Contact Us